Search
ALCO Aerosols > Meltdown Jr.

Meltdown Jr.
Meltdown Jr. is a clinging gel that works as a baseboard stripper & heavy wax buildup remover. It is designed to clean soil and finish build-up from baseboards, ceramic wall tile and similar areas.
  • Sprays upside-down for easy, quick operation.
  • Thick gel formulation stays in place on vertical surfaces for easy cleaning
  • Foaming action allows easy identification of areas already treated
Meltdown Jr. Sprays in an Inverted Position for Pinpoint Accuracy - Making It Ideal for Buildup on Baseboards, Corners & Other Hard to Reach Surfaces
​AVAILABLE IN: 20 oz. Can, 12/cs
SDS Sheet
Fact Sheet
Directions for Use:
Prior to use, test the surface in an inconspicuous area to check for discoloring or possible damage to surface.
  1. Shake well. Remove protective cap.
  2. Holding can upside-down, point opening in spray tip six inches from the surface. Press tab on the tip down to spray a thin coat.
  3. Spray to cover all soil and wax build-up on the surface. (Do not apply to painted surfaces. Wipe off any overspray immediately.)
  4. Wait at least 3 to 5 minutes for heavily soiled areas.
  5. Scrub with wet sponge or cleaning pad to remove soil and wax build-up.
  6. Rinse with clean warm water.
OTHER USES: This product can be used on baseboards, corners, edges, steps, around urinals and other hard to reach areas where wax build up occurs.
Item #:
154-22​
Sizes:
20 oz. Can, 12/cs

You May Also Like:

Melt Down
Hyper-Strip
Remove-It
ALCO Floor Care- Strippers > Melt Down Jr.

Melt Down Jr.
Meltdown Jr. is a clinging gel that works as a baseboard stripper & heavy wax buildup remover. It quickly removes soil, wax and most copolymer finishes.​
Meltdown Jr. Sprays in an Inverted Position for Pinpoint Accuracy - Making It Ideal for Buildup on Baseboards, Corners & Other Hard to Reach Surfaces
​AVAILABLE IN: 20 oz. Can, 12/cs
SDS Sheet
Fact Sheet
Directions for Use:
  1. Shake well before using.
  2. Use in upside down position only.
  3. Spray can approximately 10 to 12 inches from baseboard or surface being stripped.
  4. Apply in a thin, even coating that covers the wax.
  5. Allow for product to remain on surface for 3 to 5 minutes, longer in case of substantial build up.
  6. Wet scrub the surface with an abrasive pad or scrub brush.
  7. Repeat until all wax is removed.
  8. Rinse surface with clean water and allow for area to dry thoroughly before repolishing.
Item #:
154-22​
Sizes:
20 oz. Can, 12/cs

You May Also Like:

Melt Down
Hyper-Strip
Remove-It
Actual product appearance may vary slightly from pictured item.