ALCO Floor Care- Strippers > Hyper-Strip
Extremely effective stripper for removing water-based coatings. Designed to cut labor time by 50% on the following care programs of conditions: Heavily Burnished Floors, Conventional Scrub & Recoat, Multiple Coats, Urethane Fortified Sealers, High Speed Programs, Heavy Build Up, Resistant Sealers/Base Coats.
Each gallon at diluted rate will treat 750-1000 sq. ft.
AVAILABLE IN: 4-1 Gal/Case , 5 Gallon Pail, 55 Gallon Drum
|
DIRECTIONS:
Use in well-ventilated areas. #166 Hyper-Strip is fast acting and begins to break down finishes upon contact; floors will quickly become slippery – so use caution when wet.
Use in well-ventilated areas. #166 Hyper-Strip is fast acting and begins to break down finishes upon contact; floors will quickly become slippery – so use caution when wet.
- DILUTION RATES: For most stripping jobs, mix stripper 1:5 (1 gallon in 5 gallons hot water). Test a 1:5 dilution in a small area first then increase or decrease the dilution as necessary.
- APPLICATION OF STRIPPER SOLUTION:
- Apply a liberal amount of solution to the floor area.
- Machine scrubbing may begin within 2-3 minutes of application.
- Make certain to keep floor wet with solution; re-apply solution to areas that begin to dry.
- Because of the fast action of Hyper-Strip, it is not necessary to “pre-soak” one area while scrubbing another. To avoid waste and drying out of product, do not apply Hyper-Strip too far in advance of the scrubbing procedure.
- NOTE: If machine is not available or for areas not accessible with machines, such as church pews, mix Hyper-Strip at a 1:3 dilution ratio; apply liberally and agitate with a mop head.
- When Hyper-Strip has re-liquefied old finish, pick up with wet/dry vac. Do not allow Hyper-Strip to dry on floor.
- Scrub with a floor machine or automatic scrubber with proper pad or brush. Pick up solution with a wet vacuum or automatic scrubber.
- Repeat steps 2 and 3 if not sufficiently stripped or uniform in appearance.
- Rinse thoroughly with liberal amounts of clean cool water and pick up.
- Let floor dry completely before dust mopping.
- Apply sealer or floor finish as directed on the label of the sealer or finish.
Item #:
0166-1 0166-5 0166-55 |
Sizes:
4-1 Gal/Case 5 Gallon Pail 55 Gallon Drum |